|
Type 2100 Video Demo |
|
Covers from boot up till “Operating software Selection Screen” appeared, including self-calibration of Model-210 mainframe. 210 would execute “Self-calibration” every time after boot up; it would stop function once a comparatively bigger deviation has been found, to avoid the occurrence of erroneous tested data. Under normal operation, 210 would not perform this complicated calibration (unless reset the power), nevertheless, user can at any time uses Model-CHK01 (Simple test cable) to check whether 210 is normal or not. Continuation of part 1, covers from “Operating software Selection Screen” till ’Welcome” screen appeared. This film set Type 2100HM testing as an example, it covers the self-calibration of the artificial mouth, after boot up, if the user does not select the operating software related to microphone testing, then, no execution of artificial mouth “self-calibration”; self-calibration of the artificial mouth would be done one time after selected the test software for microphone testing, after that, even though the user has changed another operating software ( Example: Change 2100HM to 2100T ) , complicated self-calibration would longer execute, but , simple self testing would be done regularly. Continuation of part 2 film, covers from “Welcome” screen, selects “RUN” command till the “FAIL” appeared on the screen. This film covers the entire sweep test process; test speed is so rapidly that one can clearly seen from the screen, upper portion of the screen are various tested data, lower portion is the figure of frequency response curve, right part is a big red “F” (Means “FAIL”, also as “NO Go”), Operator in production line may simply just follow this judging result, and no need to understand the tested data on the upper part of the screen, easy to teach and to learn. Continuation of part 2 film, covers from “Welcome” screen, selects “RUN” command till the “PASS” appeared on the screen. The sweep test process is the same as part 3 film, big green “P” means “PASS”.
|
